DRAFT QCO NOTIFICATION FOR MANDATORY BIS CERTIFICATION OF “Valves and Taps”

OVERVIEW

In response to the Hon'ble Prime Minister's call for "Zero-defect-Zero Effect" manufacturing, DPIIT is currently developing Quality Control Orders/Technical Regulations for a variety of items.

Draft QCO for Valves and Taps have been prepared in response, which is attached below.

In this regard, DPIIT has requested that all industries, Apex Industry/Association (CII, FICCI, ASSOCHAM), Sectoral Industry/Association, Regional Industry/Association, respective Administrative Ministries, Concerned R & D Institutions/Organizations provide their comments on the Draft QCOs by December 31st, 2022.

As per this Draft QCO, The Central Government, after consulting the Bureau of Indian Standards, decides that it is necessary or expedient to issue the “Valves and Taps (Quality Control) Order, 2023” in exercise of the powers conferred by Section 16 of the Bureau of Indian Standards Act, 2016 (11 of 2016).

According to this Order, "Valves and Taps" shall have to comply with the corresponding Indian Standard and bear the standard mark (ISI Mark) under a licence from the Bureau of Indian Standards as per Scheme- I of Schedule- II of BIS (Conformity Assessment) Regulations 2018, and cannot be produced, traded/sold, stocked, or imported unless they bear the ISI Mark.

This order is not applicable to the products or articles which are meant for export.

NOTE: Any person who violates the provisions of this order will be punished in accordance with the provisions of the BIS Act, 2016.

Implementation Authority : Bureau of Indian Standards (Govt. of India)

CONCERNED AUTHORITIES

Bureau of Indian Standards Manak Bhawan 9, B.S. Zafar Marg, New Delhi - 110002
Tel: +91-11-23231903
Email: txd@bis.gov.in, cmd2@bis.gov.in

Implementation Dates: As per the notifications, the updated new standard was established on 30 Dec 2022. The existing standards will remain in force until they are withdrawn.